Seasonal Tune-Ups Inlude:

____ Inspect and Adjust Operating Pressures

____ Adjust Thermostat Calibration

____ Calibrate Blower Components

____ Clean and Inspect Burner Assembly

____ Inspect Condensate Drains and Flush/Blow them out

____ Validate Heat Exchanger

____ Inspect Cooling Coil if Accessible

____ Check Filter and Replace with Customer Supplied Filter

____ Inspect Condenser Coil

____ Lubricate all Moving Parts

____ Verify Air Flow

____ Measure Temperature Difference

____ Measure All Volts and Amps

____ Tighten All Electrical Connections and Inspect Electrical Wiring

____ Inspect for Adequate Combustion Air

____ Test for Carbon Monoxide in Living Areas

____ Test for Equipment Heat Loss with FLIR System

____ Inspect Blower and/or Burners for Cleanliness

____ Inspect Vent System for

____ Soot, Rust, Corrosion, Condensation

____ Deterioration of Exposed Vent Pipe, Flashing, and Cap

____ Proper Clearances of Vent to Combustibles

____ Proper Sizing, Pitch, and Run

____ Vent Condensation, Cap, and Drain

____ Inspect Gas Piping for:

____ Gas Leaks

____ Shut Off Valve and Approved Connector

____ Adequate Pipe Supports / Stress-free Piping

____ Inspect Burners and Pilot Assembly for Proper Alignment and Properly Adjusted Pilot Flame

____ Inspect Furnace for:

____ Flame Roll Out

____ Overheating

____ Sooting

____ Improper Venting

____ Delayed Ignition

____ Inspect Blower Door Interlock

____ Inspect Blower and Fan Control Operation / Cycle On-Off

____ Inspect Blower and Burners for Cleanliness

____ Inspect Blower Motor and Amp Draw

____ Inspect Hot Surface Resistance

____ Inspect Hot Surface Ignitor Amp Draw

____ Inspect Thermostat, Level and Secure

____ Clean and Wipe Down Accessible Parts of Furnace/Boiler

____  Inspect and Check the Relief Valve

____ Check High Limit

____ Inspect the Flame Safety Controls

____ Inspect and Oil Pump