Category: Heater Repair Dallas and Fort Worth

November 24, 2016 Todd Hoffman

Your heater can be broken for several reasons. While this list is not a substitute for a technician, who can give you a definite answer about what is broken and provide heating repair for all the problems listed, here are three of the most common heater problems:   1. One problem that occurs is sometimes on…

November 22, 2016 Todd Hoffman

Heater Tune Up — Four Safety and Efficiency Benefits from a Heater Tune Up   Can an HVAC system run cooler or heat better when it is looked at by an HVAC contractor? Here are 4 ways a HVAC can run better after a tune-up:   1. A technician will check that all safety features are…

November 21, 2016 Katie Hoffman No comments exist

The combustion efficiency of a furnace is the ability of the furnace to achieve complete combustion. When a furnace has incomplete combustion, the following things can occur: Carbon monoxide production The loss of temperature in the flame The heat exchanger looses some of its heat transfer.   Carbon monoxide poisoning is one reason why seasonal…

November 14, 2016 Todd Hoffman

Just like any other appliance, your heating system will probably break down on you at the worst possible time. These heating problems will cause frustration, but when we are dealing with Natural Gas Furnaces installed in the Keller, SouthLake, Hurst, Watauga, Bedford, Roanoke, Saginaw, Haltom City, Fort Worth, Dallas, Mid-Cities areas, these systems will normally…

November 13, 2016 Todd Hoffman

If you live in a single family home in the Fort Worth area, you probably have what’s called a ‘Split System’. This means the system is split between two places and is not sitting together as one big piece of metal. You have an AC Condenser outside on the side of your house or backyard…

November 13, 2016 Todd Hoffman

I get calls for this one a lot. A customer will say, “I hear the furnace in the attic. It sounds like it’s trying to come on, but it just never does.” When this happens, it’s usually because the system is going through some of its shutdowns and delays due to problems with the gas…